Build with your own agent
Build Atech hardware from your coding agent.
Claude Code, Codex, Cursor, Lovable, or anything that can run Python. Install the SDK, paste the prompt below, and your agent takes it from there. It builds and flashes the board offline; no cloud account needed.
Install the SDK
Python, open source, on PyPI.
Copy this prompt into your agent
Install the Atech Python SDK and use it to build my project:
pip install atech
It needs Python 3.10 or newer. Then run `atech guide` and read all of it before
anything else: it is the SDK's own manual for coding agents (the workflow, the
rules, what will bite you). `atech guide protocol` covers the wire format.
Atech is a modular electronics platform: pre-built hardware modules snap into
numbered ports on an ESP32 motherboard, with no soldering or wiring. The SDK
ships the module catalog, each module's API, and a bundled compiler that builds
and flashes the board offline.
Before you write any code, ask me:
1. Which Atech board do I have? Run `atech list-boards` to see the boards and
their ports.
2. Which modules do I own? Run `atech list-modules` to see every module the
SDK knows about, and ask me which of those I actually have in hand.
3. Which port is each module plugged into?
If I don't have a board yet, or I'm missing a module the build needs, point me
to https://atech.dev/buy and suggest which kit fits what I described.
Then:
- Run `atech new <name> --board <board id>` and describe the build in its
project.yaml, using only modules I confirmed I own and the ports I confirmed
they're in. `atech info <module>` shows a module's API.
- Run `atech validate`, then `atech build`, and fix anything they report.
Tell me first that the first build downloads the ESP32 compiler, about
2.4 GB, once.
- Run `atech upload` with my board on USB-C (a data cable), then `atech check`
to see which modules answered, and tell me what to expect it to do.What your agent will do
The prompt makes it ask about your hardware first (which board you have, which modules you own, and which port each one is in) so it only writes firmware for parts you can actually plug in. Then it runs:
$ atech guideThe SDK's manual for coding agents. Read first.
$ atech list-modulesEvery module in the catalog, with its API.
$ atech new <name> --board <id>A project.yaml, plus AGENTS.md and CLAUDE.md for the agent.
$ atech validateCheck the project before building.
$ atech buildCompile the project to ESP32 firmware, offline.
$ atech uploadFlash the board over USB-C.
$ atech checkReboot the board and see which modules answered.
No board yet?
Your agent will point you here too, with a kit that fits your build.